Editing Photo Mugs (section)

== Transferring image onto Mug==
#Preheat the Geo Knight DK3 mug press.
#Flip the on switch on the back of the unit.
#Wait for the unit to initialize.
#Press the '''PRG''' button.
#'''^''' so you see the program change to 1.
#Press the '''PRG''' to select program 1. (Essentially this is a preset for the heat, pressure and time combination that worked best in our testing. 400°F, pressure 7.00, 5.5 minutes.)
#While the press is warming up, position the transfer paper onto the mug.
#Use heat transfer tape to hold the print in place.
#Make sure that the paper is wrapped tightly around the mug.
#Wrap a piece of plain paper around the sublimation paper.
#Slide the mug into place and clamp the mug press down. This will start the timer.
#Once the timer expires, with an oven mitt, remove the mug and the transfer paper. 
#Dunk the mug into a bath of room temperature water for about 45 seconds or so.
#Mugs- 400°F, 5.5 minutes
#Water Bottles - 400°F, 3.0 minutes -- also tried it at - 400°F, 5.0 minutes and the result was just slightly darker. Next time I would try 6 minutes.
#Travel Mugs - 400°F, 1.5 minutes
#Metal Ornaments - 400°F, 1 minute 15 seconds
#Porcelain Ornaments - 400°F, 2 minutes 45 seconds--very light pressure. use nomex felt. program 7
#Ceramic Tile Magnets - 400°F, 7 minutes. Program 4