Condition prints

1. From the main print screen "Panda" select the "4-Maintenance" button. Leave the password field blank and hit OK. Select "Print Condition Setup and Check" then "[421] Paper condition setup". *The paper magazines must be preloaded and initialized (which is when the paper compartment stops making noise) before you open the Paper condition setup window.
2. Select a paper magazine (top or bottom) and hit PRINT. After the "Creating..." dialogue box disappears you can print from the other magazine or use the MEASURE function.
3. Once your condition print has been birthed from the dryer unit, slide it gradient side first (the solid black block arrows point forward) into the densitometer using the sliders to center it. Hit the green start button on the densitometer. The condition print will retract. Hit the MEASURE button on the screen and wait while a reading is taken.
4. If the window indicates the condition print is within range, move on. If the window indicates it is not within range, repeat the print and measure steps until you get an in range reading.

• Process matte papers together and glossy papers together.