Editing Mounting and Laminating (section)

===INSTALLATION NOTES===

'''1. Benchmark Menu Board''' is 15 feet wide x 21 inches tall. It is printed in 2 sections on vinyl with matte lamination and applied to 3mm / 1/8 inch sintra. For installation do NOT use a level as the main metal piece is not level. Measure 2 inches from top edge and mark with blue painters tape. It is applied with VHB tape which is purchased through Grainger. This is applied to the new piece to be installed. It should be approx 2 inches away from the edge. 

'''2. On The Alley (OTA ) Ventura (VTA)''' has 3 menu boards for menus—Beverage Menu, Main Menu, and Brophy's Menu. Actual sizes of boards:<br/>
Beverage: W= 69 inches H= 37 inches<br/>
Main: W= 108 inches H= 37 inches<br/>
Brophy's: W= 69 inches H= 37 inches

We print the actual menu on vinyl and laminate with 3M matte lamination. We print the menus smaller than the actual board size. Here are the details for each menu:<br/>
Beverage: W= 68 inches H= 36 inches<br/>
Main: W=107 inches H= 36 inches<br/>
Brophy's: W=68 inches W= 36

<i>'''For installation purposes Ventura OTA''': after the pieces have been laminated, please run them through the laminator with a small amount of heat. This relaxes the laminate, which results in easier installation. Use blue tape to mark top edges and one side of originals before removing. </i>

'''3. Window Cling Material.''' This material is applied to the inside of the glass facing out. It can be double sided or single sided. To install remove the clear backing which will expose the adhesive. Spray (fine mist) soapy water on the glass that it is being applied to as well as the exposed piece of window cling material. When both pieces have been sprayed then begin applying the material. Use a squeegee to remove the water underneath which in turn should eliminate the air bubbles as well.